Quoting: Incursus
Are they charging per correction then? Your camber is quite far out..
There is no adjustment on the Camber, apparently (ball joints).
I'm just not sure how much 0.04 degress actually is? (http://www.mkb.cc/forum/smileys/chiny.gif)
It sounds a tiny amount to worry about.?
(http://www.mkb.cc/forum/smileys/confused.gif)
Hmm.. My Total Toe was out by 0*08' degrees and both my rears were out by 0*10', my front left was only out by 0*05' and right by 0*04' but I could feel it when driving...also the steering wheel was a couple of degrees off centre.
Quoting: Cunning Plan
There is no adjustment on the Camber, apparently (ball joints).
I'm just not sure how much 0.04 degress actually is?
It sounds a tiny amount to worry about.?
Fair enough. If you can't feel it in the driving and your tires aren't wearing unevenly it's probably ok.. (http://www.mkb.cc/forum/smileys/dontknow.gif)
Quoting: Incursus
Fair enough. If you can't feel it in the driving and your tires aren't wearing unevenly it's probably ok..
Well I've just replaced all of the tyres and the front right was very badly worn on the inside, but I think that is probably more to do with the Camber than the toe? (http://www.mkb.cc/forum/smileys/huh.gif)
Quoting: Jamieg285
Where do you go to get that analysis done?
There are two places in Leighton Buzzard that use the same system....at least the print outs are identical to CP's (http://www.mkb.cc/forum/smileys/wink.gif)