Did a little more to the bus yesterday when the sun was out
I am in the middle of sorting the wiring out but I figured I wanted a nice clean working area, so I decided to repair and clean up the front cab floor. I lifted up the front rubber mat and it was not *that* bad, I think it must have had alot of the floor replaced at some point, I can even see that someone has had a good go at it with Hammerite. Although none of this I know for sure as there was NO history with the bus, pretty much just the V5 :?
Passenger side had a bit more surface rust with evidence of a long retangular repair about 30cm long. Seems to have been welded in quite well.
I wirebrushed and cleaned up the whole area chipping away the flakes, then got the POR15 out. (I bought the 6 small tins of POR15 in the end RK, tanks anyway
)
POR15 = good stuff
Finish the wiring next I think along with completing the dash, putting it all back together etc..