Quoting: Andy
It can be, but its bloody difficult.
Quoting: Roadkill
That won't take to machining.
I can't think of a way of doing it without destroying it.
Quoting: art b
i'd doubt rubber can be machined ..
Dang. I was hoping I could put it in a drill, make it spin and put a flap-disc on it or something. (http://www.mkb.cc/forum/smileys/down.gif)
Glad I didn't now! (http://www.mkb.cc/forum/smileys/TutTutSmiley.gif)
Quoting: Roadkill
Can you switch to polyeurathane ?
Urm, yes, I can't think of a reason not to (http://www.mkb.cc/forum/smileys/chiny.gif)
Any suggestions of where to look? I presume they have a selection of sizes? (http://www.mkb.cc/forum/smileys/dontknow.gif)
Quoting: Cunning Plan
Any suggestions of where to look? I presume they have a selection of sizes?
http://prothane.com/
http://energysuspension.com/
. . . .
It's just a case of finding the right O.D and I.D . . . or something close.