To be honest I was surprised that the Camaro passed it's MOT in August because the bump stops are knackered
The GM ones are made from a foam which falls apart after a few years and they cost about £60 each
After much trawling of the interweb thingy,I purchased two polyurethane Jeep bump stops from Energy Suspension ( part No. 9.9137R ) for $18.99.
Link :
http://www.energysuspensionparts.com/proddetail.asp?prod=9.9137£31.78 total delivered to UK
The main issue with fitting them is the lip on the mounting point that most people just cut off :
Well I ain't cutting my chassis about
After dissecting the old ones I realized that with some spacers ( M12 nuts and a stainless steel washer ) and longer fixing bolts, that I could utilise the old mounts and that then they would be exactly the same height as the old ones
Cut off original mount :
M12 nuts :
Stainless Steel Washers :
Longer fixing bolts :
Finished job took about an hour and a half at 5am this morning
NB : If you use an 18" socket extension you don't even have to take the wheel off