HandbrakeAfter removing any traces of rust from the Handbrake leaver, I repainted it, then sealed the back with silicone sealant, whilst leaving a small section open to allow and condensation to drain. I decided to do this as the bottom quarter of the leaver is exposed to the road and will accumulate water and dirt, leading to more rust. It just seemed logical to seal it up.
All dry, ready to be installed.
Installed on a new pivot pin with new clips and fresh grease.
Moves smoothly.
Engine Bay / Deck Lid RepairI was about to install the deck-lid rubber when I noticed that the lip which holds the rubber was bent.
So, I gently tapped it back into shape using an Allen-key as a mould, which, seemed to work well.
However, the tapping cracked some of the protection paint, therefore I had to key and degrease it ready for another top-coat.
Engine Bay / Deck Lid Rubber SealThis rubber seal came with the bus when I bought it. It was new and in a bag with 'Engine Lid Seal '68-'70' on the label, so I assume it is the correct one. However, the seal was one complete piece, which meant that the removable valance would pull the whole seal with it when it was removed for access to the engine. I decided to cut the seal at an angle and install the seal as a two piece, one on the Engine Bay surround and one on the valance.
The angle of the cuts should mean that the seal joins and seals when the Deck-lid is closed.
Project Progress:[3%] Wiring Loom diagram.
[0%] Wiring Loom component purchase. (Waiting on above)
[0%] Wiring Loom fabricate. (Waiting on above)
[0%] Paint rear drums.
[0%] Fit rear drums.
[0%] Plan and purchase complete Hydraulic braking system.
[0%] Fit Complete Hydraulic braking system.
[0%] Accelerator Peddle Components. (Going to look at Buttys Bits for this as I have read good things about his conversion kit).
[0%] Rear Windows Tints.
[0%] Rear Windows Install.
[5%] Revise Front Axle / Brake Drums / Track-Rods / Re Torque all.
[70%] Handbrake Mechanism.
[5%] Chassis Tidy (Annoying one, which delays progress. There are some areas of the chassis (more than I was expecting) which could do with tidying / sealing. Some of the joins are not as close / tidy as they should be, which I think will become a water trap.
[80%] Fit Deck-Lid / Engine hatch seal