Engine rebuilding

[Incursus]

Prices look quite reasonable...

http://www.pauls-place.com/\" target=\"_blank\" rel=\"nofollow\">http://www.pauls-place.com/

[55starchief]

Prices look about the same as most other UK builders

[Incursus]

Quoting: 55starchief

Prices look about the same as most other UK builders

Most of you guys, i guess, can do a lot of the work yourselves anyway.

[55starchief]

Quoting: incursus

Most of you guys, i guess, can do a lot of the work yourselves anyway.

Its the machine work thats the important bit mate. Once you find a good machine shop the rest is easy

[Jamieg285]

Quoting: 55starchief

Once you find a good machine shop the rest is easy

Do we know of one though?  I have a 327 that'll need doing sometime in the future.

[55starchief]

Quoting: Jamieg285

Do we know of one though? I have a 327 that'll need doing sometime in the future.

I had my crank ballanced at knight racing in daventry, they did a nice job so would definatley recomend them. As for other machine work i am sure they would also be good

[Jamieg285]

Yes, I know of Peter Knight, does a lot of work for F1 stock cars and Drag teams.  Will be good, but I reckon pricey too.

[55starchief]

Quoting: Jamieg285

Yes, I know of Peter Knight, does a lot of work for F1 stock cars and Drag teams. Will be good, but I reckon pricey too.

My crank was £150 for the ballance. The other machine work for my block which was bore and line bore was almost £400 (not done at Knight)

[Jamieg285]

£500+ for just the machining?

I might be better junking that block and starting with a new one.